Average Reviews:
(More customer reviews)There are lots of generators out there, and deciding on which to purchase can be complicated. I based my decision on getting one larger than I thought I would need so that it would not spend its life stressed to its limit. Although I had to purchase this generator elsewhere (...) and I ended up paying more for it, I am glad I did finally get it.
I suggest that you have some assistance on hand to get the VERY heavy box into your garage to set it up. Assembly took me about an hour or so, so you should be up and running in a short time. The only problem I had were the holes in the frame for mounting the rear legs were not tapped and the supplied bolts were not self-tapping (or at least to say that they were not very good at it- ther tips being quite large with no relief slot in them to cut the metal), so I had to use a 1/4 x 20 tap to create the threads before inserting the bolts. If you don't have a tap you could easily replace the bolts with some better self-tapping bolts- they are 1/4 x 20 x 1" I think.
The Vanguard motor is made in Japan and seems to be a very high quality item. Once filled with oil and fueled up it started the first time on the second or third pull adnran smoothly after about a five minute warm up in cold weather (mid- 40's F.). Pulling on the starter rope seemed quite easy and I suspect that this motor has some sort of compression relief. For anyone of average strength, I think that the starting battery would only be needed in very cold weather.
Although I would not want it running next to my bedroom all night, it does run quite a bit quieter than a lot of other generators I have heard.
Be aware that most localities require a special set up if you want to power an entire home with a generator. This special switch box is not included and it needs to be wired by a qualified electrician. If you just run some heavy extension cords to the generator, then this is not necessary. This means that to power a water well or other 220 equipment like central air conditioners the box will be necessary.
To test it, once it had warmed up, I had the idle control on (low idle speed engaged) and plugged in my portable circular saw. I hit the trigger on the saw and the generator immediately came up in RPM and the saw went to full power as if it were plugged into the wall.
Be aware that when using voltage sensitive devices and light loads like an incandescent light or two, the idle control has to be off as the generator cannot sense these small loads and will not come up to a power-prodicing RPM. My trouble light would not do anything but glow dimly at the low idle speed.
This thing is large and has a huge alternator in it. With a 10,500 watt surge rating it should handle most all your needs- maybe not all at once, but for most households this is going to be a real handy tool to have around when the lights go out.
BTW- The motor and the alternator section each have a 2 year warranty! At this price I found nothing to compare to the BS750.
Click Here to see more reviews about: Porter-Cable BSV750-W 7,500-Watt 13 HP Portable Generator
The Porter-Cable 7,500-watt 13 HP portable generator features a 13 HP Briggs and Stratton Vanguard engine with overhead valves, cast iron sleeves, low oil protection, and low tone muffler . It includes a brushless alternator, idle control switch as well as anti-vibration mounting with a wheel kit and fully-welded frame to make transportation easier. The 7-gallon tank takes unleaded fuel and powers the generator for 9.4 hours at half-load and 5.4 hours of run time at full load between fills. It includes 12 VDC, two GFCI 120 VAC duplex outlets and an easy push-button start mechanism. This generator measures 30-by-27-by-33 inches and weighs 221 pounds. It has a noise rating of 73.9 db. Manufactured in the USA, this generator is covered by a limited 2-year manufacturer's warranty.
Get 33% OFF
Click here for more information about Porter-Cable BSV750-W 7,500-Watt 13 HP Portable Generator
0 comments:
Post a Comment